I have been stumped to figure out this one. I have a Windows 10 Home 64-bit system. I built this machine about 3 years ago, and at the time was middle of the road. I have 4 GB of RAM and an A6-6400K processor. That might be where this issue lies. It is a dual core, but the way AMD made the processor it acts as a single core. I have updated all my drivers for the processor and motherboard. I have gotten the Radeon fixes for graphics and have no problems with graphics - once it loads.
My problem is that I have 4GB of RAM and the Sims 2 refuses to see more than 1GB of RAM. This is causing the system to freeze on loading. Eventually it will start, but every time I change modes or in the neighborhood switch to lot mode, the system freezes for a minute or so, and then acts fine until I switch again. Shall we say house builds are not easy at all now. I have removed all custom content from my game and still have the problem.
I attached both my Log and DX info.
![.txt]()
DxDiag.txt (Size: 68.24 KB / Downloads: 3)
![.txt]()
GALLIFREY-config-log.txt (Size: 10.26 KB / Downloads: 3)
My problem is that I have 4GB of RAM and the Sims 2 refuses to see more than 1GB of RAM. This is causing the system to freeze on loading. Eventually it will start, but every time I change modes or in the neighborhood switch to lot mode, the system freezes for a minute or so, and then acts fine until I switch again. Shall we say house builds are not easy at all now. I have removed all custom content from my game and still have the problem.
I attached both my Log and DX info.
DxDiag.txt (Size: 68.24 KB / Downloads: 3)
GALLIFREY-config-log.txt (Size: 10.26 KB / Downloads: 3)